Please send quote requests to:

Email:  This email address is being protected from spambots. You need JavaScript enabled to view it.

Phone: (888) 654-9353

Fax: (937) 253-2324

Pre-Heaters for the Pultrusion Process

Pultrusion ovens use one of the most cost-effective and fastest growing methods for production of composite materials. In this continuous process a fiber reinforcement material is pulled through a resin bath then through a set of preform plates to begin to shape the bundle. On parts with a thin cross section, the bundle is then pulled through a heated die to cure the resin. Exiting the die is a cured part ready to be cut to length. 

See typical Pultrusion Pre-Heater below:
 
 
 
 
 
For parts with a thick cross section, it is necessary to add a Thermex RF Pultrusion Preheater to the Pultrusion line. The RF Preheater is used to heat the inside of the part before it enters the heated die. This RF preheating increases the line speed and helps to produce a better quality product by reducing or eliminating stress-cracking of the part.

If you have any questions or want more information on our pre-heaters, please Contact Us.

 

 

© 2000-2017 PESCO INC dba Production Engineering

Designed and Developed by Dayton Imaging Solutions Inc.